645-4. Connecting LED and SATA CablesConnect the LED cable coming with the card to the HDD LED connector. For theconnection, see the figure below and the connection table. For the connection to themotherboard, refer to the User’s Guide of the server. If it is hard to connect the LED cable,pull out the card from the PCI slot once and connect the cable to the card.Next, connect a SATA cable to the SATA connector on the card. The channel number of theSATA cable should be the same as the channel number (port number) of the card.Port4Port3LED cableSATA cablesConnect the red cable to thispin. (This is not used for asingle-line LED cable.)Connect the blackcable to this pin.1 2 3 4 HDD LED connectorsLED cable connection tableLED cable (coming with server)2-line cable 1-line cablePin 1 Connected with red cable Not usedPin 2 Connected with black cable Connected with black cablePin 3 Not used Not usedHDD LEDconnectorPin 4 Not used Not usedNotice Depending on the type of the server, the LED cable has two lines or onlya single line. For the connection of the LED cable to the motherboard, refer to theUser’s Guide of the server. To use the N8154-09F SATA2 HDD Cage, connect the SATA cablecoming with the cage to the card. For the detailed connection, refer tothe User’s Guide of the additional HDD cage.
