19Hookup andSettingsRecording SettingsRecord Mode SetYou can set the picture quality for recording;XP (High Quality), SP (Standard Quality),LP (Low Quality), EP (Extend Quality).Record AspectWhen DVD recording, you can set the recordingaspect ratio to suit the material you’re recording (16:9or 4:3).DV Recording AudioYou need to set this if you have a camcorder using32kHz/12-bit sound connected to the front panel DVIN jack.Some digital camcorders have two stereo tracks foraudio. One is recorded at the time of shooting; theother is for overdubbing after shooting.On the Audio 1 setting, the sound that was recordedwhile shooting is used.On the Audio 2 setting, the overdubbed sound isused.TV Recording AudioWhen TV recording with bilingual, you can chooseaudio channel to record.[Main+Sub] Main language and Sub language[Main] Main language only[Sub] Sub language onlyAuto ChapterWhen recording in Video mode, chapter markers areput in specified setting. You can change this interval to5 minutes, 10 minutes or 15 minutes. If you select[None], switch off automatic chapter markingaltogether with the [None] setting.Disc SettingsDisc FormatIf you load a completely blank disc, the recorder willinitialize the disc.DVD-R: The recorder initialize the disc to Videomode. The recording mode will always be Videomode.DVD-RW/DVD+RW/DVD+R(DL): The Initializemenu will appears. Select [OK] then press ENTER.DVD-RW disc is initialized to Video mode.Also, you can reformat the DVD-RW/DVD+RW fromthe Setup menu as below.1. Select [Disc Format] option then press B.2. Press ENTER while [Start] is selected.Format Disc menu appears.3. Use b / B to select a desired mode (VR Mode orVideo Mode) then press ENTER.Confirm message will appear.For DVD+RWs, go to step 4.4. Use b / B to select [OK] then press ENTER.It takes a few moments to initialize the disc.CautionIf you want to change the disc format, everythingrecorded on the disc will be erased.