vImportant InformationNote for US ResidentsThe lamp in this product contains mercury. Please dispose according to Local, State or Federal Laws.Lamp Replacement• Use the specified lamp for safety and performance.• To replace the lamp, follow all instructions provided on page 147.• Be sure to replace the lamp and filter when the message [THE LAMP HAS REACHED THE END OF ITS USABLELIFE. PLEASE REPLACE THE LAMP AND FILTER.] appears. If you continue to use the lamp after the lamp hasreached the end of its usable life, the lamp bulb may shatter, and pieces of glass may be scattered in the lampcase. Do not touch them as the pieces of glass may cause injury.If this happens, contact your dealer for lamp replacement.A Lamp CharacteristicThe projector has a high-pressure mercury lamp as a light source.A lamp has a characteristic that its brightness gradually decreases with age. Also repeatedly turning the lamp onand off will increase the possibility of its lower brightness.CAUTION:• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector offand then disconnect the power cord. Allow at least one hour for the lamp to cool before handling.• When removing the lamp from a ceiling-mounted projector, make sure that no one is under the projector. Glassfragments could fall if the lamp has been burned out.About High Altitude mode• Set [FAN MODE] to [HIGH ALTITUDE] when using the projector at altitudes approximately 5500 feet/1600 meters orhigher.Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [HIGH ALTITUDE]can cause the projector to overheat and the protector could shut down. If this happens, wait a couple minutes andturn on the projector.• Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH ALTITUDE]can cause the lamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].• Using the projector at altitudes approximately 5500 feet/1600 meters or higher can shorten the life of optical com-ponents such as the lamp.About Copyright of original projected pictures:Please note that using this projector for the purpose of commercial gain or the attraction of public attention in a venuesuch as a coffee shop or hotel and employing compression or expansion of the screen image with the following func-tions may raise concern about the infringement of copyrights which are protected by copyright law.[ASPECT RATIO], [KEYSTONE], Magnifying feature and other similar features.Turkish RoHS information relevant for Turkish marketEEE Yönetmeliğine Uygundur.This device is not intended for use in the direct field of view at visual display workplaces. To avoid incommoding reflec-tions at visual display workplaces this device must not be placed in the direct field of view.
