NEC NP-UM330W Installation And Adjustment Manual

Also see for NP-UM330W Series: Command guide Supplementary guide Installation and assembly Technical data sheet Quick install guide

Contents

NEC NP-UM330W Installation And Adjustment Manual Manual pdf 10 page image

ENG-9Preparations:1. Prepare a Phillips screwdriver (magnetic) and the included hexagonal wrench.2. Remove the projector’s cable cover. For instructions, see the respective operating instructions.1. Remove the slide arm.The wall adapter and slide arm are assembled upon shipment.(1) Remove the two fixing screws (B) and the two safety lock screws.- Use the included hexagonal wrench for the safety lock screws.(2) Pull off the slide arm.Fixing screws (B)Safety lock screwsSlide arm(1)(2)Before installing1. Consider the place where the screen is to be installed and determine the position inwhich the wall mount unit is to be mounted. (See page ENG-7)- It is not possible to install in such a way that the image is projected at an angle. Positionin such a way that the image is projected directly to the front.2. Check that the position of installation meets the conditions in “Be sure toread before installing” on page ENG-2 of these instructions.- Because the elevation angle of the projector’s optical axis is large, small shifts in theprojection distance will change the size and position of the projected image significantly.Also, if the direction in which the projector is facing is off, the distortion of the image in-creases.Installing the Projector