NEC NP-UM330W Installation And Adjustment Manual

Also see for NP-UM330W Series: Command guide Supplementary guide Installation and assembly Technical data sheet Quick install guide

Contents

NEC NP-UM330W Installation And Adjustment Manual Manual pdf 17 page image

ENG-16CapFixing screws (B) (two)Safety lock screws4. Adjust the size of theprojected image.(1) Loosen the arm unit’s two fixing screws (B).(2) Holding the slide arm’s cap, move forward or back-ward to project the image over the entire screen.- When installed following the instructions under“Projection Distance and Screen Size”, the imageis projected at about the center.- The slide arm moves a maximum of 422 mm.- In consideration of change over time of the positionto which the projected image is adjusted, set sothat the projected image is slightly (about 20 mm)smaller than the screen.- Do not remove the safety lock screws other than for assembly. Doing so could causethe slide arm to come off and fall, resulting in injury.WARNINGForward Backward