172. Installation and ConnectionsHDMI INConnecting HDMI Input (V300X/V260X/V300W/V260W only)You can connect the HDMI output of your DVD player, hard disk player, Blu-ray player, or notebook type PC to theHDMI IN connector of your projector.NOTE: The HDMI IN connector supports Plug & Play (DDC2B).Audio cable (not supplied)HDMI cable (not supplied)Use High Speed HDMI®Cable.TIP: For users of audio video equipment with an HDMI connector:Select “Enhanced” rather than “Normal” if HDMI output is switchable between “Enhanced” and “Normal”.This will provide improved image contrast and more detailed dark areas.For more information on settings, refer to the instruction manual of the audio video equipment to be connected.• When connecting the HDMI IN connector of the projector to the DVD player, the projector’s video level can bemade settings in accordance with the DVD player’s video level. In the menu select [HDMI SETTINGS] → [VIDEOLEVEL] and make necessary settings.• If the HDMI input sound cannot be heard, in the menu select [HDMI SETTINGS] → [AUDIO SELECT] →[HDMI] (→ page 71).NOTE: HDMI signalIf the AC power supply is removed from the projector (Direct Power Off function) while displaying an image connectedto the HDMI input, the projector may not display an image properly the next time it is powered up. Should this hap-pen, power off the AC supply, power off your HDMI equipment (or disconnect the HDMI cable), and then power onthe AC supply.
