324. Convenient Features Changing Eco ModeThis feature enables you to select two brightness modes of the lamp:OFF and ON modes. The lamp life can be extended by turning on the [ECO MODE].[ECO MODE] Description Status of LAMP indicator[OFF] This is the default setting (100% Brightness). OffSTATUSLAMP[ON] Select this mode to increase the lamp life (approx.90% Brightness on V260X/V230X/V260/V230/V260W and approx.75% Brightness on V300X/V300W.)Steady Green lightSTATUSLAMPTo turn on the [ECO MODE], do the following:1. Press the ECO button on the remote control to display [ECOMODE] screen.2. Use the or button to select [ON].3. Press the ENTER button.To change from [ON] to [OFF], Go back to Step 2 and select [OFF].Repeat Step 3.NOTE:• The [ECO MODE] can be changed by using the menu.Select [SETUP] → [GENERAL] → [ECO MODE].• The lamp life remaining and lamp hours used can be checked in [USAGE TIME].Select [INFO.] →[USAGE TIME].• The projector will always enter into the [ECO MODE] [ON] condition for 90seconds immediately after the projector is turned on. The lamp condition willnot be affected even when [ECO MODE] is changed within this time period.• After a lapse of 45 seconds from when the projector displays a blue, black orlogo screen, [ECO MODE] will automatically switch to [ON]. This is done onlywhen [ECO MODE] is set to [OFF].• If the projector is overheated in [OFF] mode, there may be a case where the [ECOMODE] automatically changes to [ON] mode to protect the projector. When theprojector is in [ON] mode, the picture brightness decreases. When the projectorcomes back to normal temperature, the [ECO MODE] returns to [OFF] mode.Thermometer symbol [ ] indicates the [ECO MODE] is automatically set to[ON] mode because the internal temperature is too high.
