NEC NP110 User Manual

Also see for NP110 - SVGA DLP Projector: Control commands Technical data sheet Installation and assembly Installation and assembly Quick setup guide

Contents

NEC NP110 User Manual Manual pdf 21 page image

122. Installation and ConnectionsCOMPUTER INPHONEPHONEAUDIO IN Making ConnectionsConnecting Your PC or Macintosh ComputerNOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby modeand before turning on the power to the notebook PC.In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power manage-ment software.Enabling the computer’s external displayDisplaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector.When using a PC compatible laptop, a combination of function keys will enable/disable the external display.Usually, the combination of the ‘Fn” key along with one of the 12 function keys gets the external display to come onor off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle throughexternal display selections.VGA signal cable(supplied)To mini D-Sub 15-pin con-nector on the projector. It isrecommended that you use acommercially available distri-bution amplifier if connectinga signal cable longer thanthe cable supplied.IBM VGA or Compatibles(Notebook type) or Ma-cintosh (Notebook type)NOTE: For older Macintosh,use a commercially availablepin adapter (not supplied)to connect to your Mac'svideo port.Stereo mini-plug audio cable(not supplied)AUDIO INAUDIO IN COMPUTER 1 INCOMPUTER 2 INNP216VGA signal cable(supplied)Stereo mini-plug audiocable (not supplied)NOTE:• Before connecting an audio cable to the headphone jack of a computer, adjust the computer’s volume level to low. After connectingthe projector to the computer, adjust the volume of both projector and computer to suitable level as desired to avoid damage toyour ear.• If an audio output jack of your computer is a mini jack type, connect the audio cable to it.• An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scan converter.This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.- When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly:Project an image to fill the screen and then press the AUTO ADJ. button on the remote control or the projector cabinet.- NP215/NP210/NP115/NP110: The COMPUTER IN connector supports Plug & Play (DDC2B).NP216: Both the COMPUTER 1 IN and COMPUTER 2 IN connectors support Plug & Play (DDC2B).