212. Installation and ConnectionsInserting the PC Card1. Make sure the main power is off before inserting thePC card. (This step is needed only when the wirelessLAN card being inserted into the projector's PC CARDslot)2. Hold the PC card horizontally and insert it slowly intothe PC card slot with its top facing up.The eject button pops out once the PC card is fully inserted.Check that the PC card is fully inserted.NOTE: Do not try to force the PC card into the slot or you may bendthe pins inside the slot.Inserting and Removing a PC CardTo insert the NEC optional wireless LAN card or a PC memory card (also referred to as PC card in this manual), followthe steps below.CAUTION:* Direction for Inserting the PC CardThe PC card has a top and bottom and must be inserted into the PC card slot in a specific direction. It cannotbe inserted backwards or upside-down.Attempting to force it into the slot in the wrong direction may break the internal pin and damage the card slot.Refer to the PC card's operating instructions for the proper direction of insertion.* Back up your PC card's data in case it will need to be restored.* To prevent electrostatic discharge damage to the wireless LAN card, wear an anti-static wrist strap. If no wriststrap is available, ground yourself by touching metal such as a door knob.* Always insert or remove the wireless LAN card when the main power is turned off. Failure to do so may causeprojector malfunction or damage to the wireless LAN card. If the projector will not work correctly, turn off theprojector, wait 30 seconds, and turn it back on.PC card (not supplied)A dummy card is inserted into the PC CARD slot at the time ofshipment. First remove the dummy cards before use.ON/STAND BYSOURCEAUTO ADJUST3D REFORMSELECTON/STAND BYSOURCEAUTO ADJUST3D REFORM
