825. Installation and ConnectionsConnecting to a Wired LANThe projector comes standard with the Ethernet/HDBaseT port (RJ-45) and the LAN port which provide a LAN con-nection using a LAN cable.To use a LAN connection, you are required to set the wired LAN settings on the projector menu. Select [SETUP] →[INSTALLATION] → [NETWORK SETTINGS]. (→ page 58).The network settings can also be selected from the APPS menu.Example of LAN connectionExample of wired LAN connectionEthernetHDBaseTServerHubLAN cable (not supplied)NOTE: Use a Category 5 or higherLAN cable.NOTE:• About the projector’s Ethernet/HDBaseT and LAN portsThe Ethernet/HDBaseT and LAN ports are the same, aside from the HDBaseT function. To connect to the LAN, use only 1 of theports (it is not possible to connect both ports to the LAN).For controlling the projector by a HDBaseT transmitter whose control signal is not supported (or with which cannot connect theprojector) or over the network, connect to the LAN port. At the same time, for controlling the projector over the network that isin the state of the NETWORK STANDBY On, connect to the LAN port.
