NEC PlasmaSync 42XM4 PX-42XM4G User Manual

Contents

NEC PlasmaSync 42XM4 PX-42XM4G User Manual Manual pdf 8 page image

En-7Approx.7m/23ftMENU/ENTERINPUT SELECTDOWN UP LEFT/ - RIGHT/+ /EXITVOLUMEMENU/ENTERINPUT SELECTDOWN UP LEFT/ - RIGHT/+ /EXITVOLUMETop sideBottom side90°: RGB: RGB: AUTO: 1080B: OFF: OFF1024768EXITSEL.RETURNMENU/ENTER OKOPTION1OSMBNC INPUTD-SUB INPUTRGB SELECTHD SELECTINPUT SKIPALL RESETCaution when placing the plasma monitor in portrait mode• Use the optional unit. Contact your store of purchase when installing.• Rotate 90° clockwise as seen from the front when installing.• After installing, make sure the NEC logo is located at theleft hand side of the screen when facing the plasma fromthe front.• Be sure to set “OSM ANGLE” to “V” when using.* Failure to heed the above cautions may lead to malfunction.Using the remote controlBattery Installation and ReplacementInsert the 2 “AAA” batteries, making sure to set them inwith the proper polarity.1.Press and open the cover.2.Align the batteries according to the (+) and (–) indicationinside the case.3.Replace the cover.Handling the remote control• Do not drop or mishandle the remote control.• Do not get the remote control wet. If the remote controlgets wet, wipe it dry immediately.• Avoid heat and humidity.• When not using the remote control for a long period,remove the batteries.• Do not use new and old batteries together, or use differenttypes together.• Do not take apart the batteries, heat them, or throw theminto a fire.• When using the remote control in the wireless condition,be sure to unplug the remote cable from the REMOTEIN terminal on the monitor.Using the wired remote control modeConnect the remote cable* to the remote control’s remotejack and the “REMOTE IN” terminal on the monitor.When the cable is connected, the mode automaticallyswitches to wired remote control. When the wired remotecontrol mode is used, the remote control can be operatedeven if no batteries are loaded.* The 1/8 Stereo Mini cable must be purchased separately.External ControlIN OUTREMOTERemote ControlCable*To Remote JackOperating Range* Use the remote control within a distance of about 7 m/23ft. from the front of the monitor’s remote control sensorand at horizontal and vertical angles of up to approximately30°.* The remote control operation may not function if themonitor’s remote control sensor is exposed to directsunlight or strong artificial light, or if there is an obstaclebetween the sensor and the remote control.