English-5EnglishThis device cannot be used or installed without the TabletopStand or other mounting accessory for support. For properinstallation it is strongly recommended to use a trained,NEC authorized service person. Failure to follow NECstandard mounting procedures could result in damage to theequipment or injury to the user or installer. Product warrantydoes not cover damage caused by improper installation.Failure to follow these recommendations could result invoiding the warranty.MountingDO NOT mount the monitor yourself. Please ask dealer.For proper installation it is strongly recommended to use atrained, qualified technician. Please inspect the locationwhere the unit is to be mounted. Mounting on wall or ceilingis the customer’s responsibility. Not all walls or ceilings arecapable of supporting the weight of the unit. Productwarranty does not cover damage caused by improperinstallation, remodelling, or natural disasters. Failure tocomply with these recommendations could result in voidingthe warranty.DO NOT block ventilated openings with mountingaccessories or other accessories.For NEC Qualified Personnel:To insure safe installation, use two or more brackets tomount the unit. Mount the unit to at least two points on theinstallation location.Please note the following when mountingon wall or ceiling• When using mounting accessories other than those thatare NEC approved, they must comply with the VESA-compatible (FDMlv1) mounting method.• NEC strongly recommendsusing size M6 screws(11-12 mm + thickness ofbracket and washer inlength). If using screwslonger than 11-12 mm,check the depth of the hole.(Recommended FastenForce: 470 - 635N•cm)NEC recommends mountinginterfaces that comply withUL1678 standard in NorthAmerica.• Prior to mounting, inspect the installation location toinsure that it is strong enough to support the weight ofthe unit so that the unit will be safe from harm.• Refer to the instructions included with the mountingequipment for detailed information.InstallationMounting location• The ceiling and wall must be strong enough to supportthe monitor and mounting accessories.• DO NOT install in locations where a door or gate can hitthe unit.• DO NOT install in areas where the unit will be subjectedto strong vibrations and dust.• DO NOT install near where the main power supplyenters the building.• Do not install in where people can easily grab and hangonto the unit or the mounting apparatus.• When mounting in a recessed area, as in a wall, leave atleast 4 inches (10cm) of space between the monitor andthe wall for proper ventilation.• Allow adequate ventilation or provide air conditioningaround the monitor, so that heat can properly dissipateaway from the unit and mounting apparatus.Mounting on ceiling• Ensure that the ceiling is sturdy enough to support theweight of the unit and the mounting apparatus over time,against earthquakes, unexpected vibrations, and otherexternal forces.• Be sure the unit is mounted to a solid structure within theceiling, such as a support beam. Secure the monitorusing bolts, spring lock washers, washer and nut.• DO NOT mount to areas that have no supporting internalstructure. DO NOT use wood screws or anchor screwsfor mounting. DO NOT mount the unit to trim or tohanging fixtures.Maintenance• Periodically check for loose screws, gaps, distortions, orother problems that may occur with the mountingapparatus. If a problem is detected, please refer toqualified personnel for service.• Regularly check the mounting location for signs ofdamage or weakness that may occur over time.Orientation• When using the display in the portrait position, themonitor should be rotated clockwise so that the left sideis moved to the top and the LED indicator light is on thebottom. This will allow for proper ventilation and willextend the lifetime of the monitor. Improper ventilationmay shorten the lifetime of the monitor.MountingBracketScrewWasherUnit11-12 mmThicknessof bracketand washerScrew length should equaldepth of hole (11-12 mm) +the thickness of mountingbracket and washer.LED Indicator