Item SpecificationMaximum Output 400 mV RMS2.16 BGM/ExMOH Source Input SpecificationsTable 5-12 BGM/External MOH Source Input SpecificationsItem SpecificationOutput Impedance 600 Ω @ 1 kHzInput Level Nominal 250 mV (-10 dBm)Maximum Input 1 V RMS2.17 External Sensor Device Interface SpecificationsTable 5-13 External Sensor Device Interface SpecificationsApplied Voltage duringSensor OffLoop Current during SensorOnPort Assignment24 V 40 mA Program10-03-05: 05 V Program10-03-05: 1The External Sensor device configuration shall be assigned by system program and the programmingis different with a Sensor Type.2.18 CPU Card LAN Port SpecificationsTable 5-14 CPU Card LAN Port SpecificationsItem SpecificationStandard IEEE802.3 10Base-T and 100Base-TX CompliantAccess CSMA/CDI/F (Layer 1) Speed: 10 Mbps/100 Mbps Auto NegotiationCable: CAT5 or better, Straight/Cross Auto Crossover2.19 Cabling Requirements• Do not run extension cable in parallel with the AC source, telex or computer etc. If the cables arenear cable runs to those devices, use shielded cable with grounded shields or install the cable inconduit.• When cables must be run on the floor, cable protectors must be used.• Cable runs for Multiline Telephones, DSS Consoles, Single Line Telephones, and Doorphone Boxesmust be a dedicated, isolated cable pair.• Aerial distribution cabling is not allowed.• Trunk Lines must be installed with lightning protectors.• Do not use 4-wire cabling for SLT connections.ISSUE 3.0 SL1000Hardware Manual 5-7
