Configure the SL2100Quick Install Guide – SL2100 SLNet rev1.0 31SLNet Busy Lamp InformationThe system can show the BLF state of an extension connected to another SLNet system in the network. Thestate can be shown at either a DSS console or programmable function key set to DSS type.Maximum value = 64800 (6480 Seconds).Setting the value to zero disables the sending of SLNet Busy Lamp Information.The recommended setting is 20 (2 Seconds).The same value should be set at all systems that are setup to send Busy Lamp Information.Enter the refresh interval(value x 100 mS)
