NEC SigmaBlade N8406-022 User Manual

Contents

NEC SigmaBlade N8406-022 User Manual Manual pdf 54 page image

(English)32IMPORTANT:・ The Switch Module works with the Blade Enclosure. The SwitchModule is powered on as soon as it is installed in the powered BladeEnclosure. Therefore, make sure that the ports connected with theSwitch Module are only the ports of on-board LAN and NIC on theCPU Blade. Then, install the Switch Module in the Blade Enclosure.・ Do not hold the ejector to install the Switch Module in the BladeEnclosure. Hold the Switch Module itself and insert it into the SwitchModule slot. Inserting the Switch Module with the ejector being held,the ejector may be damaged or disengaged from the Switch Module.It may cause the personal injury if the Switch Module drops.NOTE:・ The Switch Module does not have a POWER switch.・ The STATUS LED goes on green after the period of about 10seconds from installing the Switch Module in the powered BladeEnclosure.Removal ProcedureRefer to the Blade Enclosure User’s Guide for details.1 Open the ejector of 1Gb Intelligent L2Switch to unlock.Blade Enclosure2 Pull the ejector a little.Ejector