Selecting Paper and Media 6–9Adhesive must not “spill over” its paper edge orany die cuts. Excess adhesive can bond to theprint mechanism to cause poor quality output ormechanical problems.To test for excessive adhesive, put a piece ofpaper on top of the adhesive-based paper andpress down. The two pieces should not sticktogether.TransparencyFilmWhen you are printing on transparency film, alwaysremove the first printed transparency from the outputdoor before feeding a second one through. Thisprevents scratching the film surface of the firsttransparency. The transparency must be able towithstand temperatures of 200˚C (392˚F) for 0.1seconds.Transparencies must be tested for satisfactory per-formance prior to purchase.Transparent film must be placed in and fed fromthe paper hopper one sheet at a time (do notplace several sheets in the paper hopper). Inorder to minimize curling, transparent film mustbe ejected from the face-down door.MEDIAPURCHASINGSPECIFICA-TIONSThe following purchase specifications are intendedfor the person who orders your print media. It ispossible that even when these specifications are met,operating environment inconsistencies may keep thepaper from measuring up to its optimum capabilities.Once again, always test a representative samplebefore making a large purchase of any print media.Because we cannot control the quality or manufac-turing of your selected media, we cannot warrant theuse or results of any specific media with the NECSilentwriter SuperScript 610 printer.
