NEC SuperScript 950C User Manual

NEC SuperScript 950C User Manual Manual pdf 44 page image

40 SuperScript 950C— User’s GuidePrinter is Not PoweredIndicator Light is not illuminated• Check that the printer is properly connected to thepower socket.• Press Power button .Failure ConditionThis error is identified by the following• Very rapid flashing of the light indicator.• Message from the Printer Monitor such as Carriage defector EPROM defect.Try switching the printer off then on. If the problem persistscall technical support.No Printer ReactionThere is no reaction when you switch the printer on.• Check that you have connected the printer power cableproperly, both to the printer and to the electrical powersocket.• With the Printer Cover open, press power button .• Check that the Print Cartridge Carriage moves slightlywhen you switch the printer on. If not, call technicalsupport.• Try switching the printer off and then on again. Ifnothing happens disconnect the printer and calltechnical support.Demo Page Did Not PrintIf the Indicator Light is flashing, check that you haveinstalled both print cartridges and loaded some paper in oneof the paper trays.If you tried printing the Demo Page from the PrinterOperator Panel:• Check that you have executed the sequence correctly byholding down the power button and pressing thepaper button four (4) times; then release both buttonssimultaneously.• Press the power button to switch the printer off, waita few seconds, then press the power button again.If you tried printing the Demo Page from the PrinterMonitor:• Check if a message is displayed on your PrinterMonitor. If there is, depending on its content, performthe required operation.• Try printing the Demo page again.If you still cannot print the Demo Page, try printing thewindows Test Page (from the General Tab) to check if thedriver has been correctly installed and that you do not haveany problems with printer cable connection.