NEC VT570 User Manual

Also see for VT47 Series: Control commands Command guide Command guide Control commands Specifications

Contents

NEC VT570 User Manual Manual pdf 78 page image

71No image is displayed from your PC or video equipment to theprojector.Still no image even though you connect the projector to the PCfirst, then start the PC.Enabling your notebook PC’s signal output to the projector.• A combination of function keys will enable/disable the ex-ternal display. Usually, the combination of the “Fn” key alongwith one of the 12 function keys turns the external displayon or off.No image (blue background, logo, no display).Still no image even though you press the AUTO ADJUST but-ton.Still no image even though you carry out “Reset” in theprojector’s menu.Signal cable's plug is fully inserted into the input connectorA message appears on the screen.( _____________________________________________ )The source connected to the projector is active and available.Still no image even though you adjust the brightness and/orthe contrast.Input source's resolution and frequency are supported by theprojector.7. Appendix Troubleshooting Check ListBefore contacting your dealer or service personnel, check the following list to be sure repairs are needed also byreferring to the “Troubleshooting” section in your user’s manual. This checklist below will help us solve your problemmore efficiently.* Print the following pages.Frequency of occurrence always sometimes (How often?_____________________) other (__________________)PowerNo power (POWER indicator does not light green) See also “Sta-tus Indicator (STATUS)”.Power cable's plug is fully inserted into the wall outlet.Main power switch is pressed to the ON position.Lamp cover is installed correctly .Lamp Hour Meter (lamp operation hours) was cleared afterlamp replacement.No power even though you press and hold the POWER buttonfor a minimum of 2 seconds.Shut down during operation.Power cable's plug is fully inserted into the wall outlet.Lamp cover is installed correctly .Power Management is turned off (only models with the PowerManagement function).Sleep Timer is turned off (only models with the Sleep Timerfunction ).Video and AudioImage is too dark.Remains unchanged even though you adjust the brightnessand/or the contrast.Image is distorted.Image appears to be trapezoidal (unchanged even though youcarry out the “Keystone" or “3D Reform” adjustment).Parts of the image are lost.Still unchanged even though you press the AUTO ADJUST but-ton.Still unchanged even though you carry out “Reset” in theprojector’s menu.Image is shifted in the vertical or horizontal direction.Horizontal and vertical positions are correctly adjusted on acomputer signal.Input source's resolution and frequency are supported by theprojector.Some pixels are lost.Image is flickering.Still unchanged even though you press the AUTO ADJUST but-ton.Still unchanged even though you carry out “Reset” in theprojector’s menu.Image shows flickering or color drift on a computer signal.Image appears blurry or out of focus.Still unchanged even though you checked the signal’s resolu-tion on PC and changed it to projector’s native resolution.Still unchanged even though you adjusted the focus.No sound.Audio cable is correctly connected to the audio input of theprojector.Still unchanged even though you adjusted the volume level.AUDIO OUT is connected to your audio equipment (only mod-els with the AUDIO OUT connector).OtherRemote control does not work.No obstacles between the sensor of the projector and the re-mote control.Projector is placed near a fluorescent light that can disturb theinfrared remote controls.One or more remote sensors are enabled (only models withthe Remote Sensor Selection function).Batteries are new and are not reversed in installation.If present on the remote control, projector selector switch isnot used.Buttons on the projector cabinet do not work ( only models withthe Key Lock function).Cabinet Button Lock is not turned on or is disabled in the menu.Still unchanged even though you press and hold the EXIT but-ton for a minimum of 10 seconds.