NEC VT695 User Manual
Also see for VT491: SpecificationsTechnical data sheetInstallation guideSpecificationsQuick setup guide
                                                                               | |
Contents
| 
52 Replacing the LampAfter your lamp has been operating for 2000*1 hours (up to 3000 *1 hours in Eco mode) or longer, the LAMP indicator inthe cabinet will blink red and the message [The lamp has reached the end of its usable life. Please replace thelamp.] *2 will appear. Even though the lamp may still be working, replace it at 2000*1 (up to 3000 *1 hours in Eco mode)hours to maintain optimal projector performance. After replacing the lamp, be sure to clear the lamp hour meter.(→ page 49)CAUTION• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector off,wait 30 seconds, turn off the main power switch and then disconnect the power cable. Allow at least one hourfor the lamp to cool before handling.• DO NOT REMOVE ANY SCREWS except two lamp case screws. You could receive an electric shock.• Do not break the glass on the lamp housing.Keep finger prints off the glass surface on the lamp housing. Leaving finger prints on the glass surface mightcause an unwanted shadow and poor picture quality.• The projector will turn off and go into standby mode after 2100*1 (up to 3100*1 hours in Eco mode) hours of service.If this happens, be sure to replace the lamp. If you continue to use the lamp after 2000*1 hours (up to 3000*1 hoursin Eco mode) of use, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do nottouch them as the pieces of glass may cause injury. If this happens, contact your NEC dealer for lampreplacement.*1 NOTE: Lamp life for VT59/VT49 is 3000 hours in Normal mode and 4000 hours in Eco mode.The projector will turn off and go into standby mode after 3100 (up to 4100 hours in Eco mode) hours of service.*2 NOTE: This message will be displayed under the following conditions:• for one minute after the projector has been powered on• when the POWER ON/STAND BY button on the projector cabinet or the POWER OFF button on the remote control is pressedTo turn off the message, press any button on the projector cabinet or the remote control.To replace the lamp:Optional lamp and tools needed for replacement:• Replacement lamp VT85LP (VT695/VT595/VT590/VT490) or VT80LP (VT59/VT49)1. Place the projector on a soft cloth and turn it over to access the lamp cover on the bottom.6. Maintenance |
Related manuals for NEC VT491
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine