NEC VT695 User Manual

Also see for VT491: Specifications Technical data sheet Installation guide Specifications Quick setup guide

Contents

NEC VT695 User Manual Manual pdf 63 page image

557. AppendixIndicator Condition Projector Condition NoteOffBlinking lightSteady lightGreenOrangeGreenOrange0.5 sec On,0.5 sec Off2.5 sec On,0.5 sec Off0.5 sec On,0.5 sec OffThe main power is offThe projector is getting ready to turn on.Off Timer is enabled.The projector is cooling down.The projector is turned on.The projector is in Standby.–Wait for a moment.–Wait for a moment.––Status IndicatorIndicator Condition Projector Condition NoteOffBlinking lightSteady lightRedGreenOrange1 cycle (0.5 sec On,2.5 sec Off)2 cycle (0.5 sec On,0.5 sec Off)4 cycle (0.5 sec On,0.5 sec Off)6 cycle (0.5 sec On,0.5 sec Off)NormalLamp cover error or lamp housing errorTemperature errorFan errorLamp errorRe-firing the lamp (The projector is cool-ing down.)Cabinet button is locked–Replace the lamp cover or lamphousing correctly.The projector is overheated. Movethe projector to a cooler location.Fans will not work correctly.Lamp fails to light. Wait a fullminute and then turn on again.The projector is re-firing.Wait for a moment.You have pressed cabinet buttonwhen Cabinet Button is locked.Lamp IndicatorIndicator Condition Projector Condition NoteOffBlinking lightSteady lightNormalLamp has reached its end of life. Lampreplacement message will be displayed.Lamp has been used beyond its limit. Theprojector will not turn on until the lamp isreplaced.Lamp mode is set to Eco modeRedRedGreen–Replace the lamp.Replace the lamp.– TroubleshootingThis section helps you resolve problems you may encounter while setting up or using the projector.Indicator MessagesPower IndicatorOver-Temperature ProtectionIf the temperature inside the projector rises too high, the over-temperature protector will automatically turn off thelamp with the STATUS indicator blinking (2-cycle On and Off.)Should this happen, do the following:• Unplug the power cable after the cooling fans stop.• Move the projector to a cooler location if the room where you are presenting is particularly too warm.• Clean the ventilation holes if they are clogged with dust.• Wait about 60 minutes until the inside of the projector becomes cool enough.