18NOTE: The projector is not compatible with video decoded outputs of either the NEC ISS-6020 and ISS-6010 switchers.NOTE: An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scanconverter.This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.* When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly:Project an image to fill the screen and then press the AUTO ADJ button on the remote control or the projector cabinet.2. Installation and ConnectionsAC INAUDIO OUTMONITOR OUTPC CONTROLAUDIOS-VIDEO INCOMPUTER 2 INVIDEO IN COMPUTER 1 INAUDIOL/MONO RAUDIOL/MONO RCOMPUTER 1 INBefore connections: An exclusive SCART adapter (ADP-SC1) and a commercially available SCART cable are re-quired for this connection.NOTE: Audio signal is not available for this connection.1. Turn off the power to the projector and your video equipment.2. Use the NEC ADP-SC1 SCART adapter and a commercially available SCART cable to connect the RGB input ofyour projector and a SCART output (RGB) of your video equipment.3. Connect the supplied power cable. See page 22.4. Turn on the power to the projector and your video equipment.5. Use the COMPUTER 1 button on the projector cabinet to select the COMPUTER 1 input.Use the COMPUTER button on the projector cabinet to select the COMPUTER input on VT47.6. Press the MENU button on the projector cabinet to display the menu.7. From the menu, select [Advanced] → [Signal Select] → [Computer 1 ([Computer] on VT47)] → [Scart].SCART is a standard European audio-visual connector for TVs, VCRs and DVD players. It is also referred to asEuro-connector.NOTE: The ADP-SC1 SCART adapter is obtainable from your NEC dealer in Europe. Contact your NEC dealer in Europe for moreinformation.To connect SCART output (RGB)Video equipment such as DVD playerCommercially available SCART cableFemaleADP-SC1ProjectorTo COMPUTER 1 input(COMPUTER input on VT47)