243. Projecting an Image (Basic Operation)Note on Startup screen (Menu Language Select screen)When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select oneof the 8 menu languages.To select a menu language, follow these steps:1. Use the SELECT or button to select one of the 8languages for the menu. LAMPSTATUSPOWER VIDEOAUTOADJ.S-VIDEO COMPUTER-1 COMPUTER-2ON/STAND BYSELECTENTER EXITMENUUPMAGNIFY PAGEOFFPOWERONPIC-MUTEDOWNSOURCE PIC-MUTESELECT2. Press the ENTER button to execute the selection.After this has been done, you can proceed to the menu opera-tion.If you want, you can select the menu language later. See "Lan-guage" on pages 38 and 44.LAMPSTATUSPOWER VIDEOAUTOADJ.S-VIDEO COMPUTER-1 COMPUTER-2ON/STAND BYSELECTENTER EXITMENUUPMAGNIFY PAGEOFFPOWERONPIC-MUTEDOWNSOURCE PIC-MUTESELECTNOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamplighting is stabilized.When the Lamp mode is set to Eco, the LAMP indicator will light green.If one of the following things happens, the projector will not turn on.• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In thiscondition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internalcomponents to cool down.• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute andthen turn on the power.VT670/VT470 VT570/VT47VT670/VT470 VT570/VT47