NEC VisuaLink 128/384 User Manual
Also see for VisuaLink 128: Quick installation guide
                                                                                                                                                          | |
Contents
| 
NDA-24230 Issue 2.0 Page 3-1VisuaLink 128/384 User Guide Chapter 3Chapter 3 Initial Setting and Operation CheckingAfter completing the external phase, start the initial setting of VisuaLink.3.1 Preparation ¬ Put the attached two batteries in the attached remote controller.Á Turn the VisuaLink and all external equipment power in the ON position. Position the TV monitor and the VisuaLink system so that they can be viewed.3.2 Turn Power ON orOFFThe VisuaLink can be turned ON or OFF by the POWER SWITCH on the front.Turning on the power:Press the POWER SWITCH on the front of the VisuaLink. While the unit ispowering up, the green LED power lamp and Line B1 and B2-B6 lightsimultaneously. While the system is in an initialize state, a blue screen with themessage Please wait for a while will be displayed on the monitor. When theVisuaLink has completed its initialization, the message will disappear and bereplaced with a preview video image. In addition the B1 and B2-B6 LEDs will beextinguished.Note 1: Unstable picture and sound may momentarily be output at the start of theinitialization.Note 2: If Line B1 B2-B6 LEDs do not extinguish after initialization (about 30seconds), please turn power OFF and then back to the ON position.Turning power OFF:When the POWER SWITCH is pressed while the power is in the ON position,the power turns OFF. The power lamp extinguishes when the power is OFF.POWER HEADSETPOWER LINEB1 B2-B6Power Switch Power LED |
Related manuals for NEC VisuaLink 128
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine