page 6.13iS15-2K Cinema Projector: User Manual 6. AppendixSerial control input1 unused2 Received Data3 Transmitted Data4 Data Terminal Ready5 Signal Ground6 Data Set Ready7 Request To Send8 Clear To Send9 unused at presentNull-modem cable(used to connect the projector to a computer)RD 2 --- 3 TDTD 3 --- 2 RDDTR 4 --- 6 DSRGND 5 --- 5 GNDDSR 6 --- 4 DTRRTS 7 --- 8 CTSCTS 8 --- 7 RTSModem settings• Baud rate 38,400 bps• Data length 8 bits• Parity none• Stop bits one• Handshaking Full duplex RTS/CTSXon/Xoff not supportedNotesFor more information aboutconnecting the projector, seeConnecting the projector, in2. Installation.The projector is a DTE, so use:• a straight cable to connect to amodem, or• a null-modem cable as shownhere to connect to another DTEsuch as a computer.pin view of female connector
