Appendix 39Operation using an HTTP browserOverviewThe use of HTTP server functions will allow control of the projector from a web browser without theinstallation of special software. Please be sure to use “Microsoft Internet Explorer 4.x” or a higherversion for the web browser. This device uses “JavaScript” and “Cookies” and the browser should beset to accept these functions. The setting method will vary depending on the version of browser. Pleaserefer to the help files and the other information provided in your software.NOTE• The display’s or button’s response can be slowed down or operation may not be accepted depending thesettings of your network. Should this happen, consult your network administrator.• The projector may not respond if its buttons are repeatedly pressed in rapid intervals. Should this happen, waita moment and repeat. If you still can’t get any response, pull out and then re-insert the LAN card.Access is gained to the HTTP server functions by specifyinghttp:// /index.htmlin the entry column of the URL.Preparation Before UseMake network connections and set up the projector and confirm that it is complete before engaging inbrowser operations.Operation with a browser that uses a proxy server may not be possible depending on the type of proxyserver and the setting method. Although the type of proxy server will be a factor, it is possible that itemsthat have actually been set will not be displayed depending on the effectiveness of the cache, and thecontents set from the browser may not be re-flected in operation. It is recommended that a proxy servernot be used unless it is unavoidable.Handling of the Address for Operation via a BrowserRegarding the actual address that is entered for the address or entered to the URL column when opera-tion of the projector is via a browser, the host name can be used as it is when the host name correspond-ing to the IP address of the projector has been registered to the domain name server by a networkadministrator, or the host name corresponding to the IP address of the projector has been set in the“HOSTS” file of the computer being used.Example 1: When the host name of the projector has been set to “pj.nec.co.jp”, http://pj.nec.co.jp/index.html is specified for the ad-dress or the entry column of the URL.Example 2: When the IP address of the projector is “192.168.0.10”, access is gained to the HTTP serverfunctions by specifying http://192.168.0.10/index.html for the address or the entry column of theURL.
