CHAPTER 3 INSTALLATIONUser’s Manual U16214EJ1V0UM24(2) When using clock mounted by userExecute the settings described under either (a) or (b), depending on the type of clock to be used.When starting the integrated debugger (ID78K0-NS), open the configuration dialog box and select “Internal” inthe area (Clock) for selecting the CPU clock source (this selects the emulator internal clock).(a) When using a ceramic resonator or crystal resonator• Items to be prepared• Parts board • Capacitor CA• Ceramic resonator or crystal resonator • Capacitor CB• Resistor Rx • Solder kit<1> Solder the target ceramic resonator or crystal resonator and resistor Rx, capacitor CA, and capacitorCB (all with suitable oscillation frequency) as shown below.Figure 3-10. Connections on Parts Board (When Using Main System Clock or User-Mounted Clock)Parts board (X1)Pin No. Connection2-13 Capacitor CA3-12 Capacitor CB4-11 Ceramic resonator or crystal resonator5-10 Resistor Rx8-9 ShortedCircuit diagramRemark The sections enclosed in broken lines indicate parts that are attached to the parts board.12345671413121110981 MΩ114312CB CA132510Rx9 8 CLOCK OUTHCU04 HCU04
