NORITZ AMERICA NCC1991-DV Installation Manual
                                               | |
Contents
| 
33Connecting the Quick Connect Cord to the twounits.1. Turn off the power.2. Remove the front cover of the heater (4 screws).3. Pass the Quick Connect Cord through the wiringthroughway and into the unit.4. Plug the connector on the Quick Connect Cord tothe receptacle inside the unit.5. Attach the ground wire of the Quick Connect Cordto the terminal block ¿xing plate.(If the ground wire is not attached, electricalnoise may cause problems).6. Secure the Quick Connect Cord with a clamp.7. Replace the front cover. Wiring ThroughwayCoupling CordClamp Ground wireConnectorConnectorConnecting Quick Connect Cord-2CautionFor Quick Connect Multi System Installationuse part #QC-2 only. (sold separately).Quick ConnectCord-2"Quick Connect Cord-2" tagA B1.Red2.Black3.White4.Green5.Blue6.Blue1.Red2.Black3.White4.Green5.Blue6.Blue1.Red2.Black3.White4.Green5.Blue6.Blue1.White2.Green3.Red4.Black5.Blue6.BlueThe wire coloring on the Quick Connect Cord-2 willnot be the same as the wire coloring of theconnection plug inside the unit.* The remote controller can be connected toeither unit A or B. Do not connect a remotecontroller to both units.* Disconnect the remote controller from eitherunit A or B prior to installing the Quick ConnectCord. |
Related manuals for NORITZ AMERICA NCC1991-DV
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine