NRS Healthcare Nuvo L71134 User Instructions

NRS Healthcare Nuvo L71134 User Instructions Manual pdf 1 page image

30st190kgUser InstructionsNuvoTM Slatted Bath/Shower BoardsGeneral Safety WarningPlease ensure these instructions are fully read andimplemented. Failure to do so may result in injury.Retain these instructions in a safe place for futurereference.Maximum User WeightL71134/L71201 Bath Board 26½” (673mm) L71171/L71249 Shower Board 26½” (673mm)L71146/L71213 Bath Board 27½” (698mm) L71183/L71250 Shower Board 27½” (698mm)L71158/L71225 Bath Board 28½” (724mm) L71195/L71262 Shower Board 28½” (724mm)L71169/L71237 Bath Board 30” (762mm) L71274 Grab Handle (optional)1.0 Intended UseThe NuvoTM Slatted Bath/Shower Board isdesigned to provide a safe seating or transferplatform for use when bathing or showering. It canbe used on its own or in conjunction with theNuvoTM Bath Seat to allow the user to sit lower inthe bath.2.0 Safety PrecautionsDo not exceed the maximum user weight, 30st(190kg).Check the bath seat fits correctly inside the bath.There should be a minimum of 1.5” (37mm) of levelbath rim on each side to support the board.Ensure the wing nuts are tight and the clamps aresecure prior to use.Do not attempt to stand on the seat.3.0 UnpackingRemove packaging and check all parts carefullybefore installing the product. Do not install if anyparts are damaged and contact your supplier.4.0 AssemblyPush the bracket pads (A) into the bracket locators(B).Attach the clamp bracket to the underside of theboard by screwing the wing nut (C) through thecentral slot into the corresponding screw thread.5.0 InstallationChoose the desired position of the bath board. NRSadvise the optimum position to be at the endopposite the taps.Clean and dry the bath walls thoroughly in the areawhere the board is to be fitted.Place the board across the top of the bath with thebrackets facing upwards and the edge of the boardin line with the edge of the bath.Slide one of the brackets such that the bracket padis in line with the inside edge of the bath and secureby tightening the wing nut.Take care not to over-tighten the wing nut.Turn the bath board over and locate the ‘fixed’bracket in position at the inside far edge of the bath.Slide the opposite bracket into position so that thebracket pad touches the inside near edge of thebath and secure in place by tightening the wing nut.Take care not to over-tighten the wing nut.The bath board should now feel firm and stable. Ifnot, check the bracket pads are flat against the bathwalls, if necessary repeat previous step.Bath BoardShower BoardABC

/ 2

Related manuals for NRS Healthcare Nuvo L71134