CHAPTER 14WIDTH CHANGE PROCEDURE4614. Rotate the top shaft from the 12:00 position toward the shear to decrease thegap, or away from the shear to increase the gap until the feeler gage iscaptured.15. Tighten the “C” bolt to lock the position of the shaft.16. Repeat steps 11through 15for the remainder of the bead rollers.17. Start the machine, jog the material through the bead assemblies and stop 2 to 3inches from the entry shear dies.18. Inspect the beads for depth and re-adjust as necessary.CAUTION: SHUT THE MACHINE OFF BEFORE PROCEEDING.19. Start the machine and jog the material through the bead assemblies and stop 2to 3 inches from the entry shear diesSHUT THE MACHINE OFF AGAIN BEFORE PROCEEDING.20. Remove the two “C” bolts located in the slotted holes at the bottom edge ofthe exit male shear die assembly and set the bolts and assembly aside. (Figure35)Figure 35: Shear Bolts21. Remove the two “C” bolts in the slotted holes on the entry male shear dieassembly.
