CHAPTER 15PROFILE CHANGEOVER PROCEDURE6019. Loosen the Slide Lock Bolts “D” on the top and bottom bead assemblies(Figure 21) and slide each bottom and top roll assembly left or right to centerthem on the 4” and 8” marks on the panel.20. Lock the two top bead assemblies in the correct position by tightening the “D”bolt on each assembly (Figure 21). Next align the bottom bead rollers to the topsso that the ends of the top and bottom rollers are flush with each other and tightenthe bottom “D” bolts on these 2 assemblies.21. Using a 7/16” wrench, remove the Shear Cover and set aside.Figure 56: Removing Shear Cover22. If the machine was manufactured before 10/2011 then there will be a photo eyeattached to the shear die shown in Figure 57. Using a 5/16” open end wrench,loosen, do not remove, the two bolts on the Photo Eye Bracket. It is located onthe side of the Female Exit Die Holder. Remove the Photo Eye & Bracket bysliding it off of the two bolt heads, and move out of the way.
