NXP Semiconductors MIMXRT1050 Hardware User's Manual

Also see for MIMXRT1050: Hardware user's guide Development guide

Contents

IntroductionMIMXRT1050 EVK Board Hardware User’s Guide, User's Guide, Rev. 2, 03/20182 NXP SemiconductorsFeatures of the MIMXRT1050 EVK board are shown in Table 1Table 1. Board featuresProcessor NXP Processor MIMXRT1052DVL6A(A0 silicon)MIMXRT1052DVL6B(A1 silicon)DRAM Memory SDRAM 256 Mb, 166MHz MT48LC16M16A2B4-6AIT: GDCDC MPS MP2144GJLDO UNION UM1550S-18UM1750S-00Mass StorageTF Card Slot64 Mbit Quad SPI Flash512 Mbit Hyper FlashDisplay Interface LCD ConnectorEthernet 10/100 Mbit/s Ethernet Connector. PHY Chip: KSZ8081RNBUSBUSB 2.0 OTG ConnectorUSB 2.0 Host ConnectorAudio Connector3.5 mm Audio Stereo Headphone JackBoard-Mounted MicrophoneLeft & Right Speaker Out ConnectorsSPDIF Interface(unpopulated)Power Connector 5V DC-JackDebug ConnectorJTAG 20-pin Connector (SWD by default)OpenSDA with DAP-LinkSensor FXOS8700CQ: 6-Axis Ecompass (3-Axis Mag, 3-Axis Accel)Camera CMOS Sensor InterfaceCAN CAN Bus ConnectorUser Interface Button ON/OFF, POR Reset, Reset, USER ButtonLed Indicator Power Status, Reset, OpenSDA, USER LEDExpansion Port Arduino InterfacePCB 3.937-inch x 5.9055-inch (10cm x 15cm), 4-layer board