NXR 780-0838 Care & Assembly Instructions
                      | |
Stainless steel surfaces1. Wipe all stainless steel surfaces with a wet soft cloth. Use a mild detergent to remove grease.2. Remove grease and food remains from the fire box with a plastic or wooden spatula.3. Remove the burner(s), before cleaning the fire box.Grease tray(s)1. Avoid that the grease tray(s) overflow(s). Empty regularly during use.2. Clean the grease tray(s) after each use using warm water and a mild detergent.NOTE: Add sand or cat litter to the grease tray(s) before use to avoid that the grease sticks on the surface.MAINTENANCEBefore and after each use, check the appliance or accessories or attachments for wear and damage. If required, exchange them for new ones as described in this instructionmanual. Observe the technical requirements (→ TECHNICAL DATA).Burner1. A conversion to a different gas type must be done by qualified personnel or your retailer only.2. Clean the burner(s) at least once per year or whenever they get dusty.3. Make sure that no dust or insects get inside the burner(s) openings or the air intake.4. Clean the burner(s) with a pipe cleaner. Use a wire brush to clean any rust from the surface of the burner(s).5. Make sure that the valve outlets of the valve unit are placed exactly in the air funnels of the / each burner, whenassembling the appliance. 16. Perform a visual check of the burner(s) flames regularly, do as follows:a. Remove cooking grids and flame tamers.b. Light the burner(s).c. Turn control knob(s) from LO to HI. Check the flame status, the flame in LO position should be smaller than inHI position, as figure shown below. HI LOAlways check flame before each use, if anything seems out of the ordinary (→ TROUBLESHOOTING).REPAIRThis appliance does not contain any parts that can be repaired by the consumer. Contact a qualified specialist to have it checked and repaired.WARNING!Always make sure all safeguards, if available, have been reinstalled safely and correctly after each cleaning or maintenance! Never use the appliancewithout its safeguards!STORAGE AND TRANSPORTATIONSTORAGE1. Switch the appliance off and remove the batteries.2. Clean the appliance as described above.3. Cover the burner(s) with aluminum foil so that no dust or insects collect inside.4. Collapse the substructure and secure the fire box. Refer to the illustration pages in the front section of this instruction manual for details.5. Cover the appliance with the hood cover to protect it against dust.6. Disconnect the gas cylinder(s) and store it in an outdoor location. Make sure that the gas cylinder(s) is / are not stored near heat sources or in direct sunlight.7. Do not store a spare gas cylinder under or near this appliance.8. Store the appliance and its accessories in a dry, frost-free place. The ideal storage temperature is between 10 °C and 30 °C.9. Always store the appliance in a place that is inaccessible to children.10. Clean the appliance itself and the burner(s) thoroughly before use, if the appliance has been stored for a long period of time.TRANSPORTATION1. Switch the appliance off and remove the batteries.2. Make sure the fire box is secured with its latches and the retaining wing nuts of the leg support of the substructure are properly tightened, when moving the appliance oncasters. Refer to the illustration pages in the front section of this instruction manual for details.3. Ensure the fire box is secured with the transportation clamps, when transporting the appliance collapsed.4. Attach transportation guards, if applicable.5. Always push or pull the appliance by its handle / gripping surfaces.6. Protect the appliance from any heavy impact or strong vibrations which may occur during transportation in vehicles.7. Secure the appliance to prevent it from slipping or falling over.DISPOSALEnvironmental ProtectionDiscarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively support us in conserving resources and protectingthe environment by returning this appliance to the collection centres.Do not put your used batteries, nickel cadmium, rechargeable, round cell or starter batteries in with your household rubbish. Take them to an appropriatedisposal/collection site.19 |
Related manuals for NXR 1031506
manualsdatabase
Your AI-powered manual search engine