Nady Systems UHF-16 Owner's Manual

Contents

Nady Systems UHF-16 Owner's Manual Manual pdf 6 page image

OPERATING INSTRUCTIONSUHF-16 Receiver61. Mounting the Receivera. Table MountingTo mount a receiver on a table or other horizontal surface, attach the four supplied rubber feet to thebottom corners of the receiver and place the receiver on the mounting surface.b. Rack Mounting a Single ReceiverIf you want to rack mount a single receiver in an audio equipment rack, contact the Nady Systems ServiceDepartment (see SERVICE FOR YOUR NADYWIRELESS, page 18) for an optional RMK-16SSINGLE RACK MOUNTING KIT (6a) and proceed asfollows:1. Attach the rack ears to the 2 holes on eachside of the receiver with the supplied screwsand mount the unit in the 19” audio equipmentrack.2. If you wish to also front mount the antennas, order the additional FMK-16S FRONT MOUNTCONVERSION KIT (6b) also from the Nady Service Department when ordering the RMK-16S.c. Rack Mounting 2 Receivers Side by SideIf you want to rack mount 2 receivers side-by-side in an audio equipment rack, contact the Nady SystemsService Department (see SERVICE FOR YOUR NADY WIRELESS, page 18) for an optional RMK-16DDOUBLE RACK MOUNTING KIT (6c) and proceed as follows:1. Remove the covers of both receivers byremoving the 4 screws on the bottom plateas shown.2. Join the 2 receivers together with thesupplied bolts and nuts, while also joiningthe back of the receivers with the supplieddouble side tape as shown3. Attach the rack ears to the 2 holes on theouter sides of the receivers with thesupplied screws and mount the units in the19” audio equipment rack.4. If you wish to also front mount the antennas,order the additional FMK-16D FRONTMOUNT CONVERSION KIT (6d) from theNady Service Department when orderingthe RMK-16D. This kit includes a passive antenna splitter/combiner so that the 2 CH A and CH Bantennas for both side-by-side receivers (4 total) are combined into single CH A and CH Bantennas on the front panel as shown.(6e)(6a)(6b) (6d)(6c)