Nady Systems UHF-16 Owner's Manual

Contents

Nady Systems UHF-16 Owner's Manual Manual pdf 7 page image

OPERATING INSTRUCTIONSUHF-16 Receiver72. Installing AntennasInstall antennas by connecting thetwo antennas included with yoursystem, or optional remoteantennas, to the two each BNCRF TWIST-ON CONNECTORS(5) located on the back of yourUHF-16 receiver. If using eithersingle or side-by-side front panel antenna mounting, as described above, attach either the supplied oroptional remote antennas to the FRONT PANEL BNC CONNECTORS (6e) as shown. For bestperformance, point the antenna tips away from each other at a 90° angle (45° from vertical axis).3. Powering the ReceiverPlug the AC/DC ADAPTOR (1) provided in the 12 VDC INPUT JACK (2) on the back of the receiver. Thenplug the adapter into an AC outlet.(Note: Any center positive 12V DC source with 500 mA capability canalso be used.)Turn the VOLUME CONTROL (7) counterclockwise to minimum and press the POWER SWITCH (8) ON.The POWER ON LED (9) will now light, and the receiver is operational.The LCD DISPLAY (11) should also be lit. The AUDIO LEVEL (11b) and RF LEVEL (11a) meter icons willnot display until your transmitter is turned on, your frequency selection common to both the transmitter andreceiver is made, and the system is operational. The AUDIO LEVEL METER (11b) will display when youthen speak into the attached microphone or play the connected instrument.UHF-16 BACK PANELUHF-16 FRONT PANEL(1)(2)(3)(4)(5)(5)(7)(8) (9) (10) (11) (12) (13)