Naigon Electronics Igniter 3 Setup Manual
                                          | |
Contents
| 
Page | 24When USE BOOT SOUND is enabled, the default boot.wav from the root will be played. Disabling this setting willboot with the first sound font’s font.wav.LOWPWR defines the length in seconds before the saber goes into Low Power mode, which is where the accentLEDs shut off and the motion for the menu is disabled. Handy for cons as it saves a lot of power when hanging onthe belt since the accents drain a lot of power. Setting to 0 disables the feature so that the accents and motion donot turn off.NSTRP sets the number of LEDs in the NeoPixel string blade that is being used. This allows the timing to be correctfor the Extension and Retraction Flow effects. When using an in-hilt LED, this setting is not used.4.5.2. BLADE EFFECTSThe blade effects tabs contain settings for the blade’s pulsing scheme, along with the settings for the extensionand retraction effects.ACTIVATION TYPE can be used to determine how the current font can be activated. The four choices are buttononly, button + slash, button + twist, or all three.Figure 17 – The Blade Effects tab in the Config Editor contains settings for the blade plusing along with the extension and retraction effects. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine