Naigon Electronics Igniter 3 Setup Manual
                                          | |
Contents
| 
Page | 26Adjust the main blade color with these settings. Use the Ignite-ulator™ to check for which color is currently set.Note that it is always assumed that blue is C1, green is C2 and red is C3; make sure when doing the install to set itup this way or the colors will be mixed up.BLADESHADE™ can also be adjusted from this tab. Setting this to zero means that every time the blade is turnedon it will be the exact color as set. Setting it to higher values will vary the color around the chosen color. Note thatfor any color that is zero it will not be sampled; make sure to set the color values to one for any die that should beconsidered for BLADESHADE™.4.5.4. CLASHThe Clash tab contains settings for the clash color and ClashShade™, the Clash flicker effect, and a couple othersettings related to the clash and lockup features.The LOCKKUPTYPE sets if after the Lockup is engaged if the button needs to be held, or if a simple tap will turn itoff. This is true both when Lockup was entered from the double tap and the EzLockup™ functionality.The LOCKCTYPE sets if the Lock color mirrors the clash color or the blade color. The latter allows for a morerealistic experience when doing the EzLockup™, but the former works well for demoing or showing off colors atcons.ALTERNATING CLASH toggles the new Alternating Clash feature. When enabled, the low clash color will be that ofthe blade, instead of alternating between a high and low value of the clash color.The four settings C1CLSH, C2CLSH, C3CLSH, and C4CLSH contain the settings for the clash color. Set these valuesand use the Ignite-ulator™ to see the color chosen by hitting the Lock button. Note that even if LOCKCTYPE is setto Blade the Lock button will still show the clash color to be able to choose it correctly.The values for MINCLASH, MAXCLASH, MINCLASHLEN and MAXCLASHLEN all effect the clash flicker effect. TheMINCLASH and MAXCLASH set how dramatic the effect is; bigger gaps will make it more dramatic. MINCLASHLENand MAXCLASHLEN set how quick the flicker is, where smaller values make it much quicker. Use the Ignite-ulator™while playing with these values with Lock set to see how the effect is adjusted. As with the blade effects, it isrecommended to set MAXCLASH to 98 or 99.CLSHLEN simply sets the length of the clash flicker. The blade color change is independent of the length of thesound.CLSHWAITLEN sets how long to wait before the effect can be interrupted. High values mean that once a clash isperformed a swing cannot interrupt; shorter values will allow swings to come in right after the clash happened.BLOCKLEN sets how long the aux button needs to be held before a lockup effect is triggered. Recommended is1000ms (1 second) as any shorter makes it tough to pull off the MultiPhase™ functionality by holding the auxbutton and then performing the Dual Phase™ motion. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine