Napoleon 1600C-1 Installation And Operating Instructions Manual

Also see for 1600C-1: Installation and operation instructions Installation and operating instructions Installation and operating instrictions

Napoleon 1600C-1 Installation And Operating Instructions Manual Manual pdf 25 page image

W415-0721 / B / 05.03.1125! WARNING! WARNINGIt is essential to keep the grate free of a heavy build up of ashes. Remove the grate cover by inserting the tool into the gratecover handle and lifting. Brush ashes to the grate where they will drop into the ash pan. Replace the grate cover after asheshave been removed.When burning solid fuel, always empty the ash pan at least once a day or whenever it is full of ashes. Never allow the ashpan to overfill thereby allowing ash to be in contact with the underside of the grate. If this condition is allowed, the grate willwear out prematurely. Using the door handle to open the ash pan door, remove the ash pan and dump ashes into a metalcontainer when cool. Replace the grate cover after ashes havebeen removed.DISPOSAL OF ASHES: Ashes should be kept in a metal containerwith a tight fitting lid. Keep the closed container on a non-combus-tible floor or ground, well away from all combustible materials. Theashes should be retained in the closed container until all cindershave thoroughly cooled. Cold wood ashes can be used on thegarden or in the compost.Check your chimney and chimney connector for creosote and soot buildup weekly until a safe frequency forcleaning is established. If accumulation is excessive, disconnect the appliance and clean both the chimney andthe appliance. You may want to call a professional chimney sweep to clean them. Both have to be cleaned atleast once a year or as often as necessary.IMPROPER DISPOSAL OF ASHES RESULT IN FIRES. DO NOT DISCARD ASHES IN CARDBOARDBOXES, DUMP IN BACK YARDS, OR STORE IN GARAGES.IF USING A VACUUM TO CLEAN UP ASHES, BE SURE THE ASHES ARE ENTIRELY COOLED. USINGA VACUUM TO CLEAN UP WARM ASHES COULD CAUSE A FIRE INSIDE THE VACUUM.NEVER OPERATE YOUR APPLIANCE WITH THE GRATE COVER REMOVED.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.DO NOT USE ABRASIVE CLEANERS.8.0 MAINTENANCE8.1 ASH REMOVAL PROCEDURESTOOLGRATE COVERHANDLE