Napoleon 1600C-1 Installation And Operating Instructions Manual

Also see for 1600C-1: Installation and operation instructions Installation and operating instructions Installation and operating instrictions

Napoleon 1600C-1 Installation And Operating Instructions Manual Manual pdf 32 page image

W415-0721 / B / 05.03.113210.0 TROUBLESHOOTING42.14A! WARNINGTURN OFF THE ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.DO NOT USE ABRASIVE CLEANERS.WHEN CHECKING CONNECTIONS, INSTALLING JUMPER WIRES (FOR TEST PURPOSES ONLY) ORREPLACING COMPONENTS, UNPLUG HEATER FROM THE RECEPTACLE TO PREVENT ELECTRICALSHOCK OR DAMAGE TO THE COMPONENT.PROBLEM SOLUTIONCan’t get the fire started. - Not enough kindling / paper? Add more.- Not enough air? Ensure air control is fully open.- Cold air blockage? Burn a piece of paper to establish a draft.- Use dry seasoned wood.- Flue blockage? Inspect chimney.Smokes when door isopen.- Cold air blockage? Burn a piece of paper to establish a draft.- Insufficient draft? Add more pipe.- Let air stabilize before opening door.- Ensure baffles are positioned correctly.- Negative pressure? Open a window near the appliance.Appliance emits odour. - Paint curing. See “GENERAL INSTRUCTIONS” section.Stove doesn’t burnt hotenough.- Wood is too wet.- Insufficient draft? Add more pipe.- Not enough air? Ensure air control is fully open.Wood burns too fast. - Air control may need to be adjusted down.- Check to see ash plug is properly seated (if equipped).- Check door gasket for adequate seal.- Wood may be extremely dry.Dirty glass. - Air control may be closed too far.- Burn hotter, smaller fires.- Use well seasoned wood.Blower does not run. - Appliance may not be up to temperature.- Ensure blower has power.