Napoleon Ascent X 42 Series Installation Manual

Contents

Napoleon Ascent X 42 Series Installation Manual Manual pdf 19 page image

ENW415-1794 / 06.28.1819venting requirements2.6 rear exitA. Remove the safety barrier and glass front (see "safety barrier& door removal / installation" section).B. Remove the contents from the firebox and set aside. You willneed the exhaust flue collar and the top baffle (supplied).C. To ease assembly, remove the four hex head screws securingthe deflector from inside the top front of the firebox (Fig. 1).D. Attach the deflector the top baffle using 2 screws (supplied). Set aside.E. Place the gasket (provided) over the 5" (127mm) flue collar assembly andbend along perforation.F. From inside the firebox, insert the 5" (127mm) flue collar through the back ofthe firebox. Install the rear exit shield onto the 5" (127mm) flue collar (see "rearexit shield (for rear vent only)" section).G. Secure the flue collar assembly, gasket and rear exit shield using the four hexhead 3/8" thread cutting screws (Fig. 2).H. Rest the rear edge of the top baffle(complete with deflector) on the tabs of theflue collar assembly. Reattach the deflector(complete with top baffle) using the fourscrews removed in step C (Fig. 3). Install thelog set, glass door and safety barrier.Fig. 2DEFLECTORDÉFLECTEUR Fig. 12.7 rear exit shield (for rear vent only)A. Remove the safety barrier assembly anddoor from the appliance (see “safety barrier & doorremoval / installation” section).B. Loosen the two screws, that secure theexhaust plate, and slide the baffle in place by slidingits slotted openings behind the screwheads, tightenthe two previously loosened screws. Refer to theillustration below.C. Reinstall the door and safety barrierassembly on the appliance (see “safety barrier &door removal / installation” section).! WARNING• Failure to create a seal to the firebox with the exhaust collar assembly will cause the appliance to functionimproperly and can cause injury or property damage.Do not overtighten. The gasket needs only to be snug against the firebox.note:This shield is used to block the view through the venting to the outdoors.note:DeflectorTopbaffleFlue collarassemblyFig. 3