46W415-1399 / B / 06.17.16ENEnsure that a continuous gas flow is at the burner before installing the door. When lit for the first time, the appliance willemit an odor for a few hours. This is a normal temporary condition caused by the "burn-in" of paints and lubricants used inthe manufacturing process and will not occur again.After extended periods of non-operation such as following a vacation or a warm weather season, the appliance may emit aslight odor for a few hours. This is caused by dust particles in the heat exchanger burning off. In both cases, open awindow to sufficiently ventilate the room.FOR YOUR SAFETY READ BEFORE LIGHTING:This appliance is equipped with a pilot which must be lit by hand while following these instructions exactly.Before operating smell all around the appliance area for gas and next to the floor because some gas is heavier thanair and will settle on the floor.Use only your hand to turn the gas control knob. Never use tools. If the knob will not turn by hand, do not try torepair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspectthe appliance and replace any part of the control system and any gas control which has been under water.Turn off all gas to the appliance.Open windows.Do not try to light any appliance.Do not touch any electric switch; do not use anyphone in your building. *$6.12%:$51,1*7KHJDVYDOYHKDVDQLQWHUORFNGHYLFHZKLFKZLOOQRWDOORZWKHSLORWEXUQHUWREHOLWXQWLOWKHWKHUPR-FRXSOHKDVFRROHG$OORZDSSUR[LPDWHO\VHFRQGVIRUWKHWKHUPRFRXSOHWRFRROWhen lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob is depressed slightly.$ Stop! Read the above safety information on this label.% Turn off all electric power to the appliance.& Turn the gas knob clockwise to off.' Wait five (5) minutes to clear out any gas. If you smell gas including near the floor. Stop! Follow "B" in theabove safety information on this label. If you don't smell gas go the next step.( Turn gas knob counter-clockwise to pilot.) Depress slightly and hold gas knob while lighting the pilot with the push button igniter. Keep knob depressed for oneminute, then release. If pilot does not continue to burn, repeat steps 3 through 5.* With pilot lit, depress and turn gas knob counter-clockwise to on.+ If equipped with remote on-off switch / thermostat, main burner may not come on when you turn valve to on. Remoteswitch must be in the on position to ignite burner., Turn on all electric power to the appliance.$ Turn off all electric power to the appliance if service is to be performed.% Push in gas control knob slightly and turn clockwise to off. Do not force.Immediately call your gas supplier from aneighbor's phone. Follow the gassupplier's instructions.If you cannot reach your gas supplier,call the fire department.WHAT TO DO IF YOU SMELL GAS:LIGHTING INSTRUCTIONS:TO TURN OFF GASTURN THE CONTROL VALVE TO THE OFF POSITION WHEN HEATER IS NOT IN USE.,)<28'2127)2//2:7+(6(,16758&7,216(;$&7/<$),5(25(;3/26,210$<5(68/7&$86,1*3523(57<'$0$*(3(5621$/,1-85<25/2662)/,)($/:$<6/,*+77+(3,/27:+(7+(5)257+(),5677,0(25,)7+(*$66833/<+$6581287:,7+7+(*/$66'22523(1('255(029('! WARNING8.0 OPERATION (MILLIVOLT)