Napoleon Cinema Series Installation And Operation Manual

Napoleon Cinema Series Installation And Operation Manual Manual pdf 8 page image

W415-1454 / G / 04.01.19EN82.0 locating appliance2.1 unpacking and testing applianceCarefully remove the appliance from the box and remove the support brackets. Prior to installing the appliance,remove all packaging material and test to make sure the appliance operates properly by plugging the powersupply cord into a conveniently located 120V,15 Amp minimum grounded outlet.2.2 grounding the appliance! WARNING• Due to high temperatures, this electric appliance should be located out of traffic. Keep combustible materialssuch as furniture, pillows, bedding, papers, clothes, and curtains at least 36" (91.4cm) from the front of theappliance.• Never locate this electric appliance where it may fall into a bathtub or other water container.• Wear safety gloves and safety glasses for protection during installation and maintenance.• To prevent contact with sagging or loose insulation, the electric appliance must not be installed against vapourbarrier or exposed insulation. Localized overheating could occur and a fire could result.• Do not expose the electric appliance to the elements (i.e. rain, snow, etc.).Grounding MethodsMetal Screw(A)Not allowed in CanadaGrounding MeansAdapterGrounding PinCover ofgroundedoutlet box (C)(B)This appliance is for use on 120 volts. The cord has a plug as shown in (A). An adapter as shown in (C) is availablefor connecting three-blade grounding type plugs to two-slot receptacles, as shown in (B).The green grounding plug extending from the adapter must be connected to a permanent ground such as aproperly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available.To disconnect appliance, turn controls to off, then remove plug from outlet.Must be connected to a dedicated 15 amp circuit. The use of an extension cord is NOT permitted.note: