Napoleon EFL42 Installation And Operating Instructions Manual

Also see for EFL42: Installation and operating instructions

Contents

Napoleon EFL42 Installation And Operating Instructions Manual Manual pdf 5 page image

W415-1134 / B / 07.13.15EN51.3 GENERAL INSTRUCTIONS4.8BA. Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for theoutlet are on.B. The appliance may emit a slight, harmless odour when first used. This odour is normal and it is causedby the initial heating of internal appliance elements and will not occur again.C. If your appliance does not emit heat, consult the operation section of this manual for furtherinformation.D. Use with a CSA or UL certified surge protector.E. Do not route the power cord directly underneath the appliance.This electric appliance meets the construction and safety standards of H.U.D. for application in manufacturedhomes when installed according to these instructions.! WARNINGREAD THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING INSTALLATION. FAILURE TOFOLLOW THEM COULD CAUSE AN APPLIANCE MALFUNCTION RESULTING IN SERIOUS INJURYAND/OR PROPERTY DAMAGE.ALL ELECTRIC APPLIANCES HAVE HOT AND ARCING OR SPARKING PARTS INSIDE. DO NOT USEIT IN AREAS WHERE GASOLINE, PAINT OR FLAMMABLE LIQUIDS ARE PRESENT.THIS ELECTRIC APPLIANCE IS TESTED AND LISTED FOR USE ONLY WITH THE OPTIONALACCESSORIES LISTED IN THESE INSTRUCTIONS. USE OF OPTIONAL ACCESSORIES NOTSPECIFICALLY TESTED FOR THIS ELECTRIC APPLIANCE COULD VOID THE WARRANTY AND/ORRESULT IN A SAFETY HAZARD.DO NOT OPEN. RISK OF ELECTRIC SHOCK. NO USER-SERVICEABLE PARTS INSIDE.DO NOT USE DAMAGED ELECTRICAL CORDS.SERVICING SHOULD BE DONE ONLY WHILE THE APPLIANCE IS DISCONNECTED FROM THEPOWER SUPPLY CIRCUIT.TO PREVENT ELECTRIC SHOCK MATCH THE WIDE BLADE OF PLUG TO WIDE SLOT OFRECEPTACLE AND FULLY INSERT.NOTE: As with most electronic devices, your new electric fireplace has been designed to operate attemperatures between 5°C (41°F) and 35° C (95°F). During the colder winter months, allow the fi replace toreach room temperature before turning it on.1.4 UNPACKING AND TESTING APPLIANCECarefully remove the appliance from the box. Prior to installing the appliance, test to make sure the applianceoperates properly by plugging the power supply cord into a conveniently located 120 Volt, 15 Amp groundedoutlet.