Napoleon EPA 1100 Installation And Operating Instructions Manual

Also see for EPA 1100: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions

Napoleon EPA 1100 Installation And Operating Instructions Manual Manual pdf 11 page image

11W415-0763 / 03.04.103.6 MOBILE HOMEModel 1100 is approved for installation in mobilehomes in both Canada and the United States.Model 1150/1900 is not approved for mobile homes.Model 1400/1450 is approved for installation in mobilehomes in the United States only.The pedestal base must be firmly bolted to the floorwith 1/4 inch lag bolts. For specific clearances, see“MINIMUM CLEARANCES TO COMBUSTIBLES”section.The appliance must be installed between ceilingjoists, with radiation shield and roof flashing, so thatthe structural strength, insulation and waterproofqualities of the home are not lessened. Seal withsilicone to maintain a vapour barrier at the chimneyand outside air pipe penetrations.DO NOT INSTALL IN SLEEPING ROOM.THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL AND CEILING/ROOF MUST BEMAINTAINED.THE APPLIANCE MUST BE PROVIDED WITH OUTSIDE COMBUSTION AIR.THE APPLIANCE MUST BE BOLTED TO THE FLOOR.INSTALL ACCORDING TO 24 CFR, PART 3280 (HUD).USE A CHIMNEY CERTIFIED FOR WOOD BURNING UL 103 S629, TYPE HT (2100°F).! WARNINGRAIN CAPREMOVE TOALLOW FORTRANSPORATIONMOBILE HOMEROOF FLASHINGRADIATION SHIELDCEILING SUPPORTTRIM COLLARAPPLIANCEBOLTED TO FLOORHEARTH PADOUTSIDE AIR CONNECTIONTHROUGH WALL OR FLOOR3.5.1 OUTSIDE AIR - MOBILE HOMEConnection from the stove’s air intake to outside air is mandatory in mobilehomes only, either through a hole in the wall to line up with the knockout in thepedestal back, or through a hole in the floor to line up with the hole in thepedestal base. Use a fresh air kit. Secure the 4 inch diameter aluminum linerby flaring the end once it is inserted through the 4-1/2 inch diameter hole ineither the back or base of the pedestal. If the air intake is through the floor,the hole in the pedestal back must be covered with sheet metal to avoid coldair spillage into the room. A cover plate is available from your Wolf Steel Ltd.dealer. Avoid cutting away floor joists, wall studs, electrical wires or plumbing.Seal around the outside pipe with insulation to prevent drafts.Attach the rear knockout plate (located inside the ash pan for shipping purposes).KNOCKOUTPLATE