Napoleon GD36NTR Installation And Instruction Manual

Also see for BGD36NTR: Installation and operation instructions Installation and operating instructions Installation and operating instructions Installation and operation instructions Installation and operating instructions

Contents

Napoleon GD36NTR Installation And Instruction Manual Manual pdf 52 page image

52W415-0773 / F / 08.26.13EN11.2 DOOR GLASS REPLACEMENTA. Place the door frame face down careful not toscratch the paint.B. Center the gasketed glass inside the door framewith the thick side of the gasket facing up.C. Bend the glass retainers located along the edgeof the door frame over the gasket holding theglass in place. Careful not to break the glass.! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.56.1AGLASSGASKETDOORFRAMEGLASSRETAINER11.3 CARE OF GLASS5.1DO NOT CLEAN GLASS WHEN HOT! DO NOT USEABRASIVE CLEANERS TO CLEAN GLASS.Buff lightly with a clean dry soft cloth. Clean both sidesof the glass after the first 10 hours of operation with arecommended fireplace glass cleaner. Thereafter cleanas required. If the glass is not kept clean permanentdiscoloration and / or blemishes may result.HOT GLASS WILLCAUSE BURNS.DO NOT TOUCH GLASSUNTIL COOLED.NEVER ALLOW CHILDRENTO TOUCH GLASS.! WARNING37.1A• This appliance will require maintenance which should be planned on an annual basis.• Service should include cleaning, battery replacement, venting inspection and inspection of the burner,media and firebox. Refer to the door removal section and remove the door as instructed.• Carefully remove media if necessary (logs, glass, brick panels etc).• Using a vacuum with a soft brush attachment, gently remove any dirt, debris or carbon build up from thelogs, firebox and burner. For glass media, follow the installation instructions for pre-cleaning.• Also gently remove any build-up on the pilot assembly including, if equipped; thermopile, thermocouple,flame sensor and igniter. NOTE: The flame sensor may require to be cleaned with an abrasive, suchas emery cloth, to remove any oxides. It is important that the pilot assembly is not painted.• Inspect all accessible gaskets and replace as required.• Access the blower, if equipped and clean using a soft brush and vacuum.• Re-assemble the various components in reverse order.• Inspect the relief system. The appliance relief through the main glass door or through the flaps on thefirebox top. Ensure they open freely, and close sealed.