Napoleon GD36NTR Installation And Operating Instructions Manual

Also see for BGD36NTR: Installation and operation instructions Installation and operating instructions Installation and operating instructions Installation and operation instructions Installation and instruction manual

Contents

Napoleon GD36NTR Installation And Operating Instructions Manual Manual pdf 31 page image

31W415-0773 / 06.16.094.4 MOBILE HOME INSTALLATIONThis appliance is certified to be installed as an OEM (Original Equipment Manufacturer) installation ina manufactured home or mobile home and must be installed in accordance with the manufacturer’sinstructions and the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, inthe United States or the Mobile Home Standard, CAN/CSA Z240 MH Series, in Canada. This appliance isonly for use with the type(s) of gas indicated on the rating plate. A conversion kit is supplied with the mobilehome appliance.29.1This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the unit. Builtin appliances are equipped with 1/4” diameter holes located in the front left and right corners of the base. Use #10hex head screws, inserted through the holes in the base to secure. For free standing products contact your localauthorized dealer / distributor for the appropriate securing kit. For mobile home installations, the appliance must befastened in place. It is recommended that the appliance be secured in all installations. Always turn off the pilot andthe fuel supply at the source, prior to moving the mobile home. After moving the mobile home and prior to lightingthe appliance, ensure that the logs are positioned correctly.This appliance is certified to be installed in an aftermarket permanently located, manufactured (mobile)home, where not prohibited by local codes.This appliance is only for use with the type of gas indicated on the rating plate. This appliance is notconvertible for use with other gases, unless a certified kit is used.Conversion KitsThis appliance is field convertible between Natural Gas (NG) and Propane (LP).To convert from one gas to another consult your Authorized dealer/distributor.4.5 GAS INSTALLATION! WARNINGRISK OF FIRE, EXPLOSION OR ASPHYXIATION. ENSURE THERE ARE NO IGNITION SOURCES SUCHAS SPARKS OR OPEN FLAMES.SUPPORT GAS CONTROL WHEN ATTACHING GAS SUPPLY PIPE TO PREVENT DAMAGING GAS LINE.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUTWITH THE GLASS DOOR OPENED OR REMOVED. PURGING OF THE GAS SUPPLY LINE SHOULD BEPERFORMED BY A QUALIFIED SERVICE TECHNICIAN. ASSURE THAT A CONTINUOUS GAS FLOW IS ATTHE BURNER BEFORE CLOSING THE DOOR. ENSURE ADEQUATE VENTILATION. FOR GAS ANDELECTRICAL LOCATIONS, SEE “DIMENSION” SECTION.ALL GAS CONNECTIONS MUST BE CONTAINED WITHIN THE APPLIANCE WHEN COMPLETE.HIGH PRESSURE WILL DAMAGE VALVE. DISCONNECT GAS SUPPLY PIPING BEFORE TESTING GASLINE AT TEST PRESSURES ABOVE 1/2 PSIG.VALVE SETTINGS HAVE BEEN FACTORY SET, DO NOT CHANGE.30.1Proceed once the vent installation is complete. Installation and servicing to be done by a qualified installerDo not use open flame.• Move the appliance into position and secure.• If equipped with a flex connector the appliance is designed to accept a 1/2” gas supply. Without theconnector it is designed to accept a 3/8” gas supply. The appliance is equipped with a manual shut offvalve to turn off the gas supply to the appliance.• Connect the gas supply in accordance to local codes. In the absence of local codes, install to thecurrent CAN/CSA-B149.1 Installation Code in Canada or to the current National Fuel Gas Code, ANSIZ223.1 / NFPA 54 in the United States.• When flexing any gas line, support the gas valve so that the lines are not bent or kinked.• Check for gas leaks by brushing on a soap and water solution.4.5.14.5.24.5.34.5.44.5.5