Napoleon GD70NT-S Installation And Operating Instructions Manual

Also see for StarFire GD70NT-S: Brochure & specs Installation and operation instructions Installation and operation instructions

Napoleon GD70NT-S Installation And Operating Instructions Manual Manual pdf 34 page image

34W415-0434 / G / 08.08.117.0 WIRING DIAGRAM / ELECTRICAL INFORMATION! WARNINGDO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIEDSERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THEELECTRICAL CIRCUIT.RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THEAPPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCEWITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIANELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 INTHE UNITED STATES.ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,WITH THE GLASS DOOR OPENED OR REMOVED.69.2The NIGHT LIGHT is provided with a manual “in-line” switch to turn the light on and off. There are alternatemethods of operating the light.An example of one method would be to “hard-wire” a wall switch. The switch could be installed in a desiredlocation to operate the NIGHT LIGHT plugged into one of the two receptacles on the appliance junction box.The other receptacle would still have power to operate other accessories (see schematic below).This switch could be:• Toggle • Photo cell • Remote • Motion SensorAll switches are available at your building store.LIVENEUTRALBEFORE SWITCHLIVENEUTRALAFTER