46W415-0695 / C / 03.19.1211.2 NIGHT LIGHT TM REPLACEMENTYour appliance comes equipped with our “Night Light™”. The lighthas been pre-wired and is controlled from the remote control.If in the event the lamp or lens needs to be replaced, follow theinstructions below.A. Unplug the remote receiver from the junction box locatedbehind the inner access panel.B. Remove the four screws that secure the lens frame.This frame retains the glass lens. The lamp can now beaccessed.NOTE: Do not handle the lamp (bulb) with bare fingers, protect with a clean drycloth.The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, aslamp and lens are special “high temperature” products. When re-installing, ensureintegrity of gasket seal.THE FIREBOX MUST BE SEALED.Over tightening the screws could break the lens. “Light Leakage” from the upper area may be observed. Theholes in the lamp housing are necessary for ventilation and must not be covered.GASKETLENSEFRAMECOLOURED SIDE UPSCREWSLENSEFRAMEFIREBOX TOP11.3 BLOWER REPLACEMENTYour appliance comes equipped with a heat circulatingblower. The blower is pre-wired and is controlled by theremote control supplied with the unit. For control details,see “OPERATION” section.Drywall dust will penetrate into the blower bearings,causing irreparable damage. Care must be taken toprevent drywall dust from coming into contact with theblower or its compartment. Any damage resulting fromthis condition is not covered by the warranty policy.A. Turn off the power to the appliance.B. Turn off the gas valve.C. Remove the glass door, logs, rear log support,side brick panels, rear baffle, and rear panel.D. The mounting plate can now be removed.Remove the six screws that secure the plate tothe firebox back. The blower is secured to thisplate.E. Disconnect the wire connectors and groundbefore attempting to remove the blower fromthe plate.F. When re-installing the replacement blower, itwill be necessary to replace the gasket (W290-0091) on the mounting plate.