Napoleon GD82NT-T Installation And Operating Instructions Manual

Also see for Park Avenue GD82NT-PA: Installation and operation instructions Installation and operating instructions

Contents

Napoleon GD82NT-T Installation And Operating Instructions Manual Manual pdf 39 page image

39W415-0769 / A / 12.10.108.12 IN THE EVENT OF A POWER FAILUREIf the receiver is equipped with batteries they will enable flame height control, ON/OFF or thermostatfunction to control the fireplace during a power failure. Refer to “FIREPLACE OPERATION” section whencommunications between receiver and transmitter have been lost. The will receiver emit a “beep” sound toconfirm programming has been successful once power is restored. During a power failure, if the fireplace wason, the flame height will stay at the setting prior to the failure. If off when the failure occurs and then turned on,the flame height will come on at “HI”. The flame height can then be controlled by the remote.35.148.13 FAN CONTROL MODULEControl module offers the added ability to control the fanspeed through six (6) speeds, a remotely actuated 120VAUX outlet for the NIGHT LIGHT™ and a constantlypowered 120V outlet.NOTE: Control module ON/OFF switch should alwaysbe in the “ON” position. If for any reason the moduleis turned “OFF”, the components plugged into themodule won’t have power.35.15CONSTANTLY POWERED120V OUTLETFAN OUTLET120V AUX OUTLETMAINS VOLTAGESUPPLY CORDMODULE ON/OFFSWITCH (SHOWN INTHE ON POSITION)COMMUNICATIONBUS (3 PIN)8.14 TIMED BLOWERYour remote system may have a built in timer (in thermostat mode) that enables the blower to cycle on andoff automatically when the burner turns on and off. With the remote control fan speed preset at the preferredspeed, the blower will come on approximately 5 minutes after the main burner comes on and will shut offapproximately 12 minutes after the burner shuts off.This time delay is designed to maximize the blower distribution of heated air.If at any time the burner re-ignites before the twelve minutes are over, the fan will continue to run.NOTE: At any time in the sequence, the blower can be manually turned on/off using the remotecontrol.35.19A8.11 LOW BATTERY / MANUAL BYPASSThe life span of the remote batteries depends on various factors: quality of thebatteries, the number of ignitions, the number of charges to the room thermostat setpoint, etc.When the transmitter batteries are low, a Battery Icon will appear on the LCDdisplay before all battery power is lost. When the batteries are replaced this icon willdisappear.Not applicable when plugged into 110V.When the receiver batteries are low, no “beep” will be emitted from the receiverwhen it receives an ON/OFF command. This in an alert for the receiver that there’s low battery. When thebatteries are replaced the “beep” will be emitted from the receiver when the ON/OFF key is pressed.If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding thethree position slider switch on the receiver to the “ON” position. This will bypass the remote control feature andthe appliance main burner will come on if the gas valve is in the “ON” position.35.1376°FON