Napoleon GDS60N Installation And Operating Instrictions

Also see for GDS60-N: Installation and operating instructions Installation and operation instructions Installation and operating instructions

Napoleon GDS60N Installation And Operating Instrictions Manual pdf 22 page image

22W415-0788 / 05.15.09Example 8:V1 = 1.5 FTV2 = 5 FTVT = V1 + V2 = 1.5 + 1 + 5 = 6.5 FTH1 = 1 FTH2 = 1 FTH3 = 10.75 FTHR = H1 + H2 + H3 = 1 + 1 + 10.75 = 12.75 FTH O = .03 (four 90° elbows + one 45° elbow - 90°)= .03 (360° + 45° - 90°) = 6.75 FTH T = HR + HO = 12.75 + 6.75 = 19.5 FTH T + VT = 19.5 + 6.5 = 26 FTFormula 1:HT < 3 VT3 VT = 3 x 6.5 = 19.5 FT19.5 = 19.5Formula 2:H T + VT < 40 FT26 < 40Since both formulas are met, this vent configuration is acceptable.90°V 1V2H 1H 290°90°H345°18.2_33.1 ORIFICE REPLACEMENTREAR VENT TERMINATION:In rear exit installations with no vertical vent run, the BTU input mustbe reduced to 21,000 BTU by changing the orifice.In order to access the orifice, the log support secured by two screws,must be removed.Care should be taken not to damage the gas pipe. When removingthe orifice, using a 9/16" socket wrench, a 7/8" back-up wrench mustbe used on the manifold, located below the housing, to ensure thatthe aluminum tubing does not twist or kink.3.0 INSTALLATION PREPARATION - MODEL GDS60NorthlineExpress.comhttp://www.northlineexpress.comToll-Free 1-866-667-8454