Napoleon GDS60N Installation And Operating Instrictions

Also see for GDS60-N: Installation and operating instructions Installation and operation instructions Installation and operating instructions

Napoleon GDS60N Installation And Operating Instrictions Manual pdf 39 page image

39W415-0788 / 05.15.099.2 VENTURI ADJUSTMENTThis appliance model has an air shutter that has been factory set open according to the chart below:Closing the air shutter will cause a more yellow flame, but can lead to carboning. Opening the air shutter willcause a more blue flame, but can cause flame lifting from the burner ports. The flame may not appear yellowimmediately; allow 15 to 30 minutes for the final flame color to be established.AIR SHUTTER ADJUSTMENT MUST ONLY BE DONE BY A QUALIFIEDINSTALLER! AIR SHUTTEROPENINGVENTURIORIFICE49.29.4 RESTRICTING VERTICAL VENTS - MODEL GDS60Vertical installations may display a very active fl ame. If this appearance is not desirable, the vent exit must berestricted using the restrictor vent kit, GDSRP-KT. This will reduce the velocity of the exhaust gases, slowingdown the flame pattern and creating a more traditional gentle appearance. Specifi c instructions are includedwith the kit.9.3 FLAME CHARACTERISTICSIt’s important to periodically perform a visual check of the pilot and burner flames. Compare them to the illustra-tions provided. If any flames appear abnormal call a service person. 3/8” - 1/2”PILOTBURNERFLAME MUST ENVELOPUPPER 3/8” TO 1/2” OFFLAME SENSORFLAMESENSORELECTRODE54.1GDS60NG 3/8”LP 5/16”10.0 MAINTENANCECAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerousoperation. Verify proper operation after servicing. This appliance and its venting system should be inspected before use andat least annually by a qualified service person. The appliance area must be kept clear and free of combustible materials,gasoline or other flammable vapours and liquids. The flow of combustion and ventilation air must not be obstructed.1. In order to properly clean the burner and pilot assembly, remove the logs exposing both assemblies.2. Keep the control compartment, logs, burner, air shutter opening and the area surrounding the logs clean by vacu-uming or brushing, at least once a year.3. Check to see that all burner ports are burning. Clean out any of the ports which may not be burning or are not burn-ing properly.4. Check to see that the pilot flames are large enough to engulf the thermocouple and the thermopile on one leg andreaches toward the burner on the other leg.5. Replace the cleaned logs.6. Check to see that the main burner ignites completely on all openings when the gas knob for the burner is turned on.A 5-10 second total light-up period is satisfactory. If ignition takes longer, consult your Napoleon® dealer/distributor.7. Check that the door gasketing is not broken or missing. Replace if necessary.MAINTENANCEMAINTENANCEMAINTENANCETURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.! WARNINGNorthlineExpress.comhttp://www.northlineexpress.comToll-Free 1-866-667-8454